Home > Error Code > Sms Protocol Error

Sms Protocol Error

Contents

CMS ERROR 8 "Operator determined barring" This cause indicates that the MS has tried to send a mobile originating short message when the MS's network operator or service provider has forbidden Everyone with GSM gets spooty as best coverage no matter what carrier. Please note that CMS errors are modem specific errors, which means, the best you can do to find out what an error code means is to check your modem's manual. Footer Navigation Contact Us Sitemap Terms of Use Privacy Policy © 2016 SMSSolutions.net All rights reserved. have a peek here

MS busy for MT SMS: The message is rejected because of congestion encountered at the visited MSC. Point-to-Point and Point-to-Omnipoint (cell broadcast) What is Point-to-Point? All rights reserved Software PBX for Windows | VoIP SDK | Legal information | Privacy policy | Terms of use Please, address your inquiries to [email protected] Skip to main content Our Please Check for New Rules. http://forums.pinstack.com/f343/protocol_error_sending_sms_mms-47785/

Sms Error Codes List

Why use SMS? DTEK60 DTEK50 Priv Passport Classic Z30 Z10 Q10 Leap Where is OS 10.3.3? If this document does not help, take a look at the following table: CMS ERROR 1 "Unassigned (unallocated) number" This cause indicates that the destination requested by the Mobile Station cannot SM-MO denotes the capability of the GSM system to send a message from an M to an SME via an SC and to provide information to the MS about the delivery

This ... If the MS is switched on and idle, it is able to identify and ignore re-broadcasts of messages that have already been received. What is SM-MT (short message - mobile terminated)? Sm Delivery Failure Cause CMS ERROR 38 "Network out of order" This cause indicates that the network is not functioning correctly and that the condition is likely to last a relatively long period of time;

Do not retry.414Number unroutable on current settings. Help Remember Me? vBCredits II Deluxe v2.1.0 (Lite) - vBulletin Mods & Addons Copyright © 2010-2016 DragonByte Technologies Ltd.Runs best on HiVelocity Hosting. https://supportforums.blackberry.com/t5/BlackBerry-OS-Smartphones/SMS-Text-Protocol-Error/td-p/44158 What is the maximum length of a Point-to-Omnipoint short message?

Lines highlighted in green relate to the message returned if the message is sent successfully.Routing-code:1 (MO)There is no specific ErrorCode of this route. Absent Subscriber Error Code Everyone with CDMA gets great reception no matter what carrier in the building. SMS can also be used as a transport for binary payloads and to implement the WAP stack on top of the SMSC bear. because I forget to resend and think it automatically would resend the messages and it doesnt.

Subscriber Busy For Mt Sms

My Blog , My Flickr 10-11-2007,07:38 AM #3 KSmithInNY Stack level 1 Join Date Jul 2007 Posts 4 Re: Protocol error sending SMS / MMS Originally Posted by melissaox I have i dont kno how to do a downgrade. Sms Error Codes List The sender indicates the frequency and duration of transmission. Equipment Protocol Error Sms The message state value is also attached in a SMPP Optional Parameter “message_state” value 0x0427 described in the SMPP Protocol Specification v3.4 Issue 1.2 chapter 5.3.2.35. 4.

At the origination point, the sender (or network operator) broadcasts messages on certain "channels". Reply johnniesgirl627 CrackBerry Newbie Posts 1 Posts 06-25-09,11:05 PM #6 Go into tools, go to SMS, go to network, and change it from GPRS to GSM. An error message will be sent to the SC if this transmission is not possible. The front-end would simply be a section for the message (limit) and a destination address (mobile number). Absent Subscriber Error

  1. SMS-STATUS-REPORT: sending a status report from the SC to the MS.
  2. The easy solution would be to switch to verizon or sprint but if you've ever dealt with one of these companies you know this is not an option lol!
  3. Do not retry.417Number unroutable.
  4. Report Inappropriate Content Message 2 of 2 (7,372 Views) Reply 0 Likes « Message Listing « Previous Topic Next Topic » BlackBerry.com/Support | Mobile Site | Full Site Legal Copyright ©
  5. sms is not formed correctly  386sms sent, no delivery report received.  387sms submit from smsgw to smsc failure  388sms window exceeded.  389smsc congestion  390smsc failure  391smsc roaming  392ss_err_status  393ss_incompat  394ss_notavail  395ss_subviol  396ss-errorstatus  397ss-incompatibility  398ss-notavailable  399ss-subscriptionviolation  400subscriber absent  401subscriber barred  402subscriber busy  403subscriber busy for mt short message  404subscriber not provisioned  405subscriber

In the Americas, phones typically support English, Spanish, and Portuguese. Introduction The error codes listed in this table are called CMS ERROR codes. Click Here to Register Register Please Check Please Check New Rules for Download in Announcement Area. CMS ERROR 69 "Requested facility not implemented" This cause indicates that the network is unable to provide the requested short message service.

as far email goes, everything the same, but sms sucks. Protocol Stack Error Globe CMS ERROR 27 "Destination out of service" This cause indicates that the destination indicated by the Mobile Station cannot be reached because the interface to the destination is not functioning correctly. Two-way data transport = 140 Octet Data Payload Supports Either: 140 bytes for binary data transport (PDU format) 160 characters for text messaging transport (7-bit ASCII).

CMS ERROR 99 "Information element non existent or not implemented" This cause indicates that the equipment sending this cause has received a message which includes information elements not recognized because the

CMS ERROR 128 Telematic interworking not supported x CMS ERROR 129 Short message Type 0 not supported x x CMS ERROR 130 Cannot replace short message x x CMS ERROR 143 GsmFavorites.com Internet resource for mobile communication software. Messages states A message will always be in one of the following states: Message state Value Description ENROUTE 1 Message is in the process of being sent to the destination Delivered Smpp Error Codes Do not retry.41A Number unroutable.

manufacturer specific Dig deeper! The delivery acknowledgement will be sent to the SC regardless of whether or not the message was forwarded to the external device. Unknown subscriber: message is rejected because there is no directory number for the mobile subscriber (GSM 09.02). Posted by Jared DiPane 9 hours ago News & Rumors | 138 Comments As of November 9, TELUS My Account app will no longer be supported on BlackBerry 10 and older

Desktop | Mobile | Mobile Lite Advertising Partner

Welcome! People who read this also read... which happened from time to time with my 8100, but now, if I write 6 or 7 sms while in the tube, they ALL get the protocol error and when the Your cache administrator is webmaster.

All Rights Reserved About Us Contact Us Sitemap | Affiliate Disclosure Site Rules Privacy Statement Terms of Service | Top CrackBerry.com Forums Ask a Question New Posts Trending Discussions BlackBerry DTEK60 Voice/Fax Notifications Delivery of Replacement Ringtones, Operator Logos and Group Graphics Mobile users will select features or options for their phone (ideally from a web site). On a lighter note i decided to find out what the " wipe my phone" feature in the security screen does and found out it completely wipes everyone off your phone When look at the message it says "protocol error".

roaming restriction.  108absent subscriber: the message is undeliverable  109age verification failure failed av  110age verification failure no previous av  111age verification failure parental lock  112age verification failure temporary av error  113agent not registered  114anti spam  115ati not allowed  116bad parameter BlackBerry officially announces the DTEK60 No tricks October BlackBerry Android software updates BBRY New ads highlight BlackBerry software pivot Destined for Mercury BlackBerry patents new keyboard authentication methods Updates Unlocked AT&T Memory capacity exceeded: message rejected because the MS doesn't have enough memory. CMS ERROR 28 "Unidentified subscriber" This cause indicates that the subscriber is not registered in the PLMN (i.e.

Classes identify the message's importance as well as the location where it should be stored. In Europe it is vastly different.