Home > Smart Error > Smart Error Error/status Code 0159

Smart Error Error/status Code 0159

Unless the system has an extended battery warranty or the battery is a GREEN Labeled 3 year battery, battery failures outside the 1st year of use is not covered by the You can get more information on possible resolutions to your issue and even get a part dispatched if needed.. Repeat the PSA diagnostics. Re-Test Drive 105 BUSY GLITCH The drive did not properly respond to test commands. Source

Update to the latest BIOS. If a memory error is detected, try memory modules individually. The drive may not have been accessed properly possibly due to a bad connection. PSA NA ePSA 2000-8002 BIOS - Sensor [x] exceeded thermal zone [d]. find more

Update to the latest BIOS. Update to the latest BIOS. Reseat the connections to the computer. The drive has not responded to the SMART test request.

Repeat the PSA diagnostics. Replace Drive 557 SERVO 2-9 SERVO is data on track location. Disconnect any USB devices and run the diagnostic again. Re-test Drive 220 Drive is Locked Security feature of the drive reports locked status.

Your hard drive has indicated a failure. Repeat the PSA diagnostics. Re-test 132 Command Error Command Aborted. https://support.wdc.com/KnowledgeBase/answer.aspx?ID=11711 PSA NA ePSA 2000-0713 Sensor - Error accessing thermal sensor.

Several instances of information on data positioning and location could not be found. BIOS detected a hard drive issue. Replace the drive if the error repeats. Update to the latest BIOS.

Make note of not only the error and validation code, but which component is listed Error Number (PSA and ePSA) Error Message What does this mean? http://www.zive.cz/poradna/co-znamena-pri-testu-pevneho-disku-smart-error/sc-20-cq-151679/?consultanswers=1 Krause s Bradym pustila i s tvrdými útoky na Zemana Štefan Margita přiznal dcerušku! Retest after checking the connections. I have read in one place that 0159 means the electronics are failing.

Repeat the PSA diagnostics. this contact form You can get more information on possible resolutions to your issue and even get a part dispatched if needed. a měl by sám dát zavčas vědět, kdyby se zvýšila pravděpodobnost nějakého závažného problému. Update to the latest BIOS.

Check cabling and retest. For more info, see your user guide. If the diagnostics still results in an error code, visit our ePSA online tool. http://phabletkeyboards.com/smart-error/smart-error-0159.php If the diagnostics still results in an error code, visit our ePSA online tool.

If the diagnostics still results in an error code, visit our ePSA online tool. Drive should be replaced. Re-Test Drive 4 Open Drive Failure Cannot communicate with drive.

In order for S.M.A.R.T.

Drive should be replaced. Update to the latest BIOS. This error may have internal and external reasons. If a memory error is detected, try memory modules individually.

Drive should be replaced. multiple log on's on one xp profile 15. Re-Test Drive 115 ICRC Error Ultra DMA CRC error. Check This Out PSA NA ePSA 2000-0512 Fan - the (s) fan is running faster than expected.

You can get more information on possible resolutions to your issue and even get a part dispatched if needed. When you run the diagnostics and receive a error code, and you require further assistance, please visit our ePSA online tool. Re-Test Drive 103 Write Fault Error A Write command during the test has failed to complete. Replace the drive if the error repeats.

The IPMI System Event Log is full for various reasons or logging has stopped because too many ECC errors have occurred. The drive has not responded in the time allotted. This may be due to a defect with the drive or a bad connection. Check cabling & retest.

It also may be due to a defective connection. Re-Test Drive 108 Seek Not Complete A Seek command did not complete in the time allotted. Update to the latest BIOS. Note: When you call in or report a error code online you may be asked for the validation or status code, in addition to the actual error code.

Update to the latest BIOS. If diagnostics fail again after the BIOS is at the most current version, contact Technical Support to resolve the problem. Top Mikippp Post subject: Posted: April 21st, 2006, 7:45 Joined: May 30th, 2005, 17:07Posts: 421 Hi, Can anybody send me modules 25 and 44 for this HDD (WD400LB-07DNA2) PSA NA ePSA 2000-0723 Hard Drive – Drive error detected.

No, create an account now. In order for S.M.A.R.T. Replace. This may be an anomaly or a defect with the drive.